A study on the machinability behaviour of Al–TiC composite prepared by in situ technique
作者: Ram Naresh RaiG.L. DattaM. ChakrabortyA.B. Chattopadhyay
作者单位: 1Department of Mechanical Engineering, Indian Institute of Technology, Kharagpur 721302, India
2Department of Metallurgical and Materials Engineering, Indian Institute of Technology, Kharagpur 721302, India
刊名: Materials Science & Engineering A, 2005, Vol.428 (1), pp.34-40
来源数据库: Elsevier Journal
DOI: 10.1016/j.msea.2005.11.040
关键词: Metal-matrix compositesIn situ techniqueShaping operationChip formationCutting force
原始语种摘要: Abstract(#br)With the wide range of applications of metal-matrix composites (MMCs), the machining of these materials has become a very important subject for research. This paper discusses the experimental investigation on chip formation and cutting force measurement during shaping operation of Al–TiC MMCs produced by the in situ technique and compared with those for Al–TiAl 3 composite and Al–Si alloys. The machinability of MMCs was characterised by the nature of chip formed, cutting force and machined surface produced. It was observed that there was improvement in the quality of the machined surface with increased amount of TiC particles in the composite. The cutting force for Al–TiAl 3 composite and Al–Si was higher than that for Al–TiC composite. The machinability studies were...
全文获取路径: Elsevier  (合作)
分享到:
来源刊物:
影响因子:2.108 (2012)

×
关键词翻译
关键词翻译
  • cutting 伐木
  • technique 技术
  • machinability 可加工性
  • composite 复合的
  • force 
  • shaping 成形
  • study 学习
  • behaviour 性质
  • operation 运算
  • produced 出品